I'm making this for a Dayton HO 10" sub....it handles 600watts RMS and I'm gonna be pumping every bit of that to it!
I've got a ways to go but its getting there. When I'm done sanding I'm going to give it some texture and and dye it charcoal probably......I usually change my plans 2 or 3 times along the way so we'll see.

Looks like you are well on your way. Nice, post pic's when done, should be sweet.

This was supposed to be a simple box and It turned into a lot of work...

I'm not sure wher to mount the amps.. They are both 18" long. I was planning on stacking them under one seat but I'm afraid of heat.

I just have the OEM setup so I don't know, but is there room behind the back seat on the bulkhead? If there is you could use adhesive to secure them and wouldn't have to deal with screw holes. All your work looks like it well pay off.

Nice work. I've been known to make a little sawdust from time to time myself.

Ended up covering my box with textured bed liner paint.... The amp is going behind it where the jack was.

nice.......that far from simple though, looks good!

__________________
'04 2wd with PRG stuff......



"Wait a minute. What did you just say? You're predicting $4-a-gallon gas? ... That's interesting. I hadn't heard that." --George W. Bush, Feb. 28, 2008

Sure looks good, that was a good idea. The black is fine but IMHO color matched gray would look better. Just my , ether way you did a great job.

Nice setup!!!

The box had some surgery... The new sub was deeper than the original and I had to fix it. I'll post a pic tomorrow...