Nissan Titan Forum



Go Back   Nissan Titan Forum > Interior
Home Today's Posts Forums Garage

Interior Everything from Floor Mats to Seat Covers.

Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 09-18-2006, 06:54 PM
Squid's Avatar
Hazardous Waste
 
Join Date: Sep 2006
Location: South Central kansas
Posts: 5,751
:

Removal of center console...

Compliments of 40oz to freedom at another site.


How to remove the center console:

1. Apply parking brake, shift transmission to neutral, disconnect battery, remove front seats.

2. Remove left and right side lower trim panels at bottom front of console under dash, next to floor. Pull straight out on the piece towards the rear of the truck, then pull the panel towards the rear of the truck. They are held on by plastic clips.

3. Remove two phillips screws under lower trim panels at the front lower side portions of the center console.

4. Unscrew and remove gear shift knob.

5. Open hinged console box lid and pull rubber mat from bottom of center console box & remove three screws (2 phillips & 1 torx).

6. Remove two exposed bolts, one on each side of center console toward the rear.

7. Pull out rubber square just rearward of shift gate assembly & just forward of small open box area. Remove two torx.

8. Pull up on shift gate assembly to unclip.

9. Disconnect wire connectors under shift gate assembly and disengage wire connector plastic holding clips from holes.

10. Pull shift gate assembly up past shift lever and set aside (you can't do this with shifter in park).

11. Remove two phillips screws under shift gate assembly at forward end of console.

12. Pull up on flange of metal spring clip to release shift cable (very little force required).

13. Wipe a little of the excess silicon grease on the bushing for the shift cable yoke and push the yoke sideways off of the bushing, toward the passenger door.

14. Remove 3 or 4 harnesses.

15. Lift rear of console and move rearward being sure to clear lower left corner of glovebox.

15. Remove console from truck to reveal console bracket.

16. Remove obvious bolts to disengage bracket from floor.
Reply With Quote
Links
  #2 (permalink)  
Old 09-19-2006, 01:20 AM
The One! The Only! Mighty Mod!
 
Join Date: Sep 2006
Location: Texas! Is there anywhere else?!.........edit: There is also Iraq
Posts: 1,266
:
This is alot easier than it sounds.
Reply With Quote
  #3 (permalink)  
Old 09-26-2006, 08:37 PM
miserytom's Avatar
Electro Mod
 
Join Date: Sep 2006
Location: Jacksonville , NC
Posts: 433
:
here are a few diagram pages to help





__________________
My Myspace Page
My Durango Page
Reply With Quote
  #4 (permalink)  
Old 10-24-2006, 09:26 PM
WindsorFox's Avatar
Crazy Like A Fox
 
Join Date: Sep 2006
Location: Hell
Posts: 268
:
Is it a necessity to remove one or both seats? All I want to do is poke a radio under and inside teh console. Maybe I should consider under the seat by the voofer....
__________________
steves: I prefer to fantasize about women with pronounceable (to me) names.

Squid: Like "Ho"?
-------------------------------------------------------------------------
Reply With Quote
  #5 (permalink)  
Old 10-27-2006, 08:46 PM
miserytom's Avatar
Electro Mod
 
Join Date: Sep 2006
Location: Jacksonville , NC
Posts: 433
:
you dont really need to remove the seats, the very back piece of the console pops open if u need it to, and the 2 bolts that are next to the seats you can get to if need be without removing the seats, its tight, but u can do it
__________________
My Myspace Page
My Durango Page
Reply With Quote
  #6 (permalink)  
Old 10-27-2006, 10:02 PM
WindsorFox's Avatar
Crazy Like A Fox
 
Join Date: Sep 2006
Location: Hell
Posts: 268
:
Quote:
Originally Posted by miserytom View Post
you dont really need to remove the seats, the very back piece of the console pops open if u need it to,
And how, pray tell; does one do that??
__________________
steves: I prefer to fantasize about women with pronounceable (to me) names.

Squid: Like "Ho"?
-------------------------------------------------------------------------
Reply With Quote
  #7 (permalink)  
Old 10-28-2006, 06:50 AM
miserytom's Avatar
Electro Mod
 
Join Date: Sep 2006
Location: Jacksonville , NC
Posts: 433
:
you can see a little crease on the sides of the console, take a flat head screwdriver and pry it open
__________________
My Myspace Page
My Durango Page
Reply With Quote
  #8 (permalink)  
Old 10-28-2006, 11:23 AM
WindsorFox's Avatar
Crazy Like A Fox
 
Join Date: Sep 2006
Location: Hell
Posts: 268
:
Quote:
Originally Posted by miserytom View Post
you can see a little crease on the sides of the console, take a flat head screwdriver and pry it open
Hmm. I guess if I had cods the size of grapefruit that wouldn't be a problem. Until then, I think Imma put it on the floor under the seat beside the subwoofer.
__________________
steves: I prefer to fantasize about women with pronounceable (to me) names.

Squid: Like "Ho"?
-------------------------------------------------------------------------
Reply With Quote
Links
Reply


Thread Tools
Display Modes


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -5. The time now is 10:28 AM.



SquidWorkz is Infiniti EX35_ FJ Cruiser_ Cummins Turbo Diesel_ Nissan Rogue_ Toyota Venza_ Ducati SuperBike_ Toyota Tundra


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2012, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.0
© 2006-2008, Squidworkz

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73